Adjusting The Shock Absorber - SWM Superdual E4 2017 Guía Rápida

ADJUSTING THE SHOCK ABSORBER

The rear shock absorber is calibrated for running
with the rider plus a small bag only. It is thus rec-
ommended to adjust the shock absorber setting
(spring preload) when riding with a passenger.
WARNING*: The shock absorber adjustment
affects both the stability and the handling of
the motorcycle. After changing the standard
suspension setting, ride with care. We advise
measuring the reference distance "A" before
making any change.
WARNING*: Never disassemble the shock ab-
sorber, which contains compressed gas. Con-
tact your SWM Dealer for any major service.
B: rear mudguard top height
C: rear wheel axle height
A
ADJUSTING THE SHOCK ABSORBER SPRING PRELOAD
Proceed as follows:
- Operate on the adjustment knob (1); screw it to
increase the pre-load, unscrew it to decrease the
pre-load.
- If necessary, refer to the notches (2), marking the
adjustment according to use: pilot only, pilot +
passenger, pilot + passenger + luggage.
Pre-load must be adjusted according to the load,
leaving it at the minimum value if only the pilot is
present, or bringing it to the maximum value at full
load.
WARNING*: If bags are assembled, refer to the
B
manual for "Operating limits".
WARNING*: Be careful not to touch hot exhaust
pipe while adjusting the shock absorber.
1
C
2
EN - 19