TECshow NAVIGATOR SPLIT 8 Manual De Usuario página 9

Multiple Movingheads DMX Set Up
Note: Link all cables before connecting electric
power.
Controlling
After having addressed all the fixtures, you may
now start operating these via your lighting control-
ler. If there is no data received at the DMX-input, the
problem may be:
• The XLR cable from the controller is not con-
nected with the input of the first fixture.
• The controller is switched off or defective, the
cable or connector is detective, or the signal
wires are swapped in the input connector.
Note: It's necessary to insert a XLR termination
plug (with 120 Ohm) in the last fixture in order to
ensure proper transmission on the DMX data link.
English version | Tecshow Navigator Split 8
P. 9