Genesis GMDB1215LF Manual Del Operario página 12

Sierra ingleteadora de bisel doble deslizable de 305 mm
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CHANGING THE BLADE (FIG 6 - 9)
1. Unplug the saw.
2. Lift up the lower blade guard (1).
3. Loosen the front blade guard screw (2) until it releases the
blade bolt cover (3). Notice the screw must be backed out
enough to clear the tab on the blade bolt cover. No other
screws should be loosened.
4. Depress the spindle lock (4) and rotate the blade until the
spindle lock engages.
5. Using the blade wrench provided (5), loosen the blade bolt
(6) by turning it clockwise. Remove the blade bolt.
6. Remove the outer blade flange (7).
7. Remove the old blade from the saw.
NOTE:
A blade washer may be use for the blade with arbor
hole bigger than 5/8 inch.
8. Mount the new blade carefully onto the spindle, being sure
that the directional arrow on the blade surface matches the
arrow on the upper blade guard.
9. Replace the outer blade flange and the blade bolt.
10. Depress and hold down the spindle lock while tightening the
blade locking bolt securely in a counter-clockwise direction.
11. Lower the blade bolt cover completely until it is fully seated
in the downward position and retighten the blade guard pivot
screw securely. Slight downward pressure on the rear portion
of the lower blade guard may be required to properly seat
the lower blade bolt cover.
12. Raise and lower the blade guard several times by hand to
make sure it operates properly.
13. Raise and lower the saw head several times to make sure
the blade guard functions properly.
14. B e sure the spindle lock has released and the blade rotates
freely before plugging in the tool and making a cut.
DEPTH OF CUT ADJUSTMENT (FIG 10)
WArNINg:
unplugged from the power source. Accidental saw
start-up could result in serious personal injury.
NOTE:
The miter saw should come adjusted properly for depth
of cut while using the factory-installed blade for normal operation.
The downward travel or depth of cut, of the saw blade can be
controlled to prevent contact with the metal surfaces of the miter
saw, to insure the blade completely cuts through the workpiece,
and permit depth of cut settings for special operations.
To Adjust The Miter Saw Blade's Cutting Depth
:
NOTE
This is factory set and usually does not require
adjusting. (This saw may not come with the necessary tools for
the following procedure.)
1. Locate the cutting depth adjustment (1+2) assembly on the
left side of the saw arm near the dust port.
2. If the saw arm is locked in the down position, release it by
pulling the saw arm lock knob out.
3. Loosen the nut (2) counter-clockwise several turns. Using the
5mm Allen wrench, loosen or tighten to adjust the stop bolt (1). Clockwise rotation will raise the depth
of cut; Counter-clockkwise will lower the depth of cut.
12
Be sure the machine is
12" Dual-Bevel Sliding Compound Miter Saw
Operator's Manual
FIG 6
1
FIG 7
2
3
FIG 8
4
FIG 9
1
2
FIG 10
GMSDB1215LF
7
6
5
3
4
5

Publicidad

Tabla de contenido
loading

Tabla de contenido