Dexter 900ID2.5 Instrucciones Legales Y De Seguridad página 197

2. SAFETY INSTRUCTIONS
DRILL SAFETY WARNINGS
DRILL SAFETY WARNINGS
SAFETY INSTRUCTIONS FOR ALL OPERATIONS
a) Wear ear protectors when impact drilling.
hearing loss.
b) Use the auxiliary handle(s),
c) Brace the tool properly before use. This tool produces a high output torque
and without properly bracing the tool during operation, loss of control may occur
resulting in personal injury.
Hold the power tool by insulated gripping surfaces, when
d)
performing an operation where the cutting accessory may contact
hidden wiring or its own cord. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live" and could give the
operator an electric shock.
SAFETY INSTRUCTIONS WHEN USING LONG DRILL BITS
a) Never operate at higher speed than the maximum speed rating of
the drill bit. At higher speeds, the bit is likely to bend if allowed to rotate
freely without contacting the workpiece, resulting in personal injury.
b) Always start drilling at low speed and with the bit tip in contact
with the workpiece. At higher speeds, the bit is likely to bend if allowed to
rotate freely without contacting the workpiece, resulting in personal injury.
c) Apply pressure only in direct line with the bit and do not apply
excessive pressure. Bits can bend causing breakage or loss of control,
resulting in personal injury.
• If possible, always use clamps or a vice to hold your work.
• Always swit
• Ensure that the lighting is adequate.
• Keep the area free of tripping hazards.
• Only use accessory bits in good condition.
• Before drilling, check that there is
the workpiece.
• Do not touch the bit after operation. It will be very hot.
• Keep your hands away from under the workpiece.
• Never use your hands to remove dust, chips or waste close by the bit.
• Rags, cloths, cord, string and the like should never be left around the work area.
• Support the work properly.
Loss of control can cause personal injury.
re you put the drill down.
nt clearance for the drill bit under
197
Exposure to noise can cause
FR
ES
PT
IT
EL
PL
UA
RO
EN