Publicidad
Idiomas disponibles
Idiomas disponibles
UNFOLDING YOUR UNIT.-
If you wish to use the treadmill, do the
reverse procedure. Use your foot to
press lever (O) in the direction of the
arrow as shown in Fig.6 and slowly
lower the treadmill belt down to the fl
oor. When folding or unfolding the
treadmill make sure that there are no
children about or obstacles that might
hin- der the folding motion.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (10),
Fig.7 to make it easier to move. Make
sure that the mains cable is unplugged
from the wall socket.
If you wish to move the treadmill, the
first thing to do is to fold it up, place
your hands on the handrails (M & N)
and tilt the treadmill, Fig.7, so that the
wheels (10) rest on the floor.
To prevent accidents DO NOT move
the treadmill across uneven floors.
MAINTENANCE.-
Use the bottle of lubricant (127) to
lubricate the inside of the belt Fig.8 in
order to keep your unit in top condition
and to ensure that friction between the
belt and the board is kept to a
minimum (due to different running
styles, always apply more lubrication
to the area where you place your feet
during the exercise).
It is advisable to lubricate the base of
the belt between the board and the
band depending on how often it is
used.
<3
<6
1 year
6-
6
12
months
>12
3
months
Note: This preventive maintenance
schedule is only meant for home use.
It is suggested to maintain the unit
every month for commercial use.
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the Allen key
(124) and with the machine set to 4
km/h turn screws (R & L) one turn in a
clockwise direction.
ADJUSTING THE BELT.-
If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways. Rigorous
quality control adjusts and checks the
running belt. However, due to weight
differences and individual styles of
running, the belt may be prone to shift
sideways.
If the belt does shift to the left or right,
stop the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important.
Follow these steps. In order to adjust
the belt, set the unit in motion at a
speed of 4km/h. If the belt has moved
to the right, turn screw (R) on the
right-hand side of the machine a 1⁄4
turn clockwise. Note the position of the
belt, if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the left then turn
the right screw back slightly in an
anticlockwise direction Fig.9.
16
Hours per week
3-7
6
months
3
months
2
months
>7
3
months
2
months
1
month
Publicidad
