Wiring - Craftmade Ellington FARII13ABZ3RW Guia De Instalacion

6. Wiring.

CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the diagram to the
right, please use a qualified electrician.
WARNING: If using this fan in a DAMP location,
this fan must be connected to a supply circuit
that is protected by a Ground Fault Circuit
Interrupter (GFCI) to reduce the risk of personal
injury, electrical shock or death.
When downrod is secured in place on the
hanging bracket, wire the RECEIVER with wire
connectors provided as shown in diagram at
right.
Tip: While you are wiring, keep in mind that
wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push wires and taped wire
connectors into outlet box. Let antenna rest
outside of hanging bracket.
IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch. Wire the WALL CONTROL
with wire connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 on the wall control.
Factory setting is pre-set and not recommended
for use. Write down number sequence for use in
Section 8.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate
to wall control using 2 screws provided in the wall
control.
white supply wire
black supply wire
blue
white
black
from fan
from receiver
black
white
blue
(wiring for receiver)
outlet box
(AC IN from
breaker box)
(wiring for wall control)
page 5
black
from ceiling
from receiver
black
AC IN L
white
AC IN N
receiver
antenna
wall
control
green/ green/ green/
bare bare
bare
ground ground ground
green
black (OUT to fan)
black
black
(TO POWER supply)
black
ground (green
or bare)
plate
code
switches