SN2013/IR, SN2033/IR
1
Install Unit
A
Remove Access panel and with
the help of another person, place
unit in position against both walls .
B
Ensure unit is level, shimming floor unit if
necessary . Mark the wall anchor locations .
2
Connect Water Supply to Valve Assembly
WARNING! Do not turn on water until
Step 4 is completed!
Connect stops to hot and cold water supply .
A
Connect one end of each supply hose to a
stop and the other end to the hot and cold
inlets of the Navigator TMV .
6
Rough-in of plumbing lines, wall braces
and electrical box must be completed
before unit can be properly installed.
Water Supply
Gang Valve
Assembly
OPTIONAL TEMPERED LINE CONNECTION: Connect one
B
end of the supply hose to the stop and the other end to the
tempered line adapter in the gang valve assembly .
8/15/2014
Install suitable wall anchors (supplied
C
by installer) for 3/8" bolts at the marked
locations . Secure unit to wall .
Red Tube
(to Aerator)
Green Tube
(to Aerator)
Black Tube
(to Aerator)
Navigator
®
TMV
Cold Supply Inlet
Stop Valve
Bradley • 215-923 Rev. L; ECN 14-00-007
Installation
Water Supply
Gang Valve
Assembly
OPTIONAL
Tempered Line
Adapter Assembly
(S39-804)
Braided
Hose
Hot Supply Inlet