Omnitronic DSS-2 Manual Del Usuario página 26

1. PHONO / LINE-SWITCH
Used to select the input to be sent to the individual channel.
2. GAIN-CONTROL
Used to set the level of the input signal.
3. TALKOVER-SELECTOR
The TALKOVER-selector has 3 different functions:
OFF: the microphone is switched off.
MIC ON: the microphone is activated.
TALKOVER: the level of all other signal-sources is attenuated by 14 dB, so that the microphone can clearly
be heard.
4. MIC LEVEL-CONTROL
With the MIC LEVEL control, you can adjust the microphone volume.
5. TREBLE-CONTROL
Used to increase or lower the HIs of the input signal.
6. MIDDLE-CONTROL
Used to increase or lower the MIDs of the input signal.
7. BASS-CONTROL
Used to increase or lower the LOWs of the input signal.
8. CHANNEL-FADER
Used to adjust the input level of each channel.
9. MASTER LEVEL DISPLAY
The display shows the level of the left and right master output.
10. CROSSFADER
Mixes the signals of one channel with another. If the crossfader is in the center-position, both channels can
be heard at the same volume.
11. MASTER CONTROL
Adjusts the level of the master output.
12. CUE LEVEL-CONTROL
With the Cue Level-control, you can adjust the phones volume without changing the output signal.
13. CUE MIXING-FADER
Selects the channel for monitoring. The monitor signal comes from Prefader. This means it will not be
affected by the channel faders.
Connect your headphones to the HEADPHONES jack. With the CUE MIXING-fader you can select the
desired channel.
14. CUE SPLIT/CUE MIX-SWITCH
Cue Split-function: the Cue-signal is on the one side of the headphones and the output-signal on the other
side.
Cue Mix-function: the adjustable mix of Cue-signal and output-signal is on both sides of the headphones.
26/64 10553155_V_1_0.DOC