Clean Intake Housing; Cleaning Agents - Bosch 800 Serie Manual De Uso

Replace filters and front panel before using downdraft.
Be sure to engage TABS on front panel behind EARS as
shown.
CAUTION
Failure to engage tabs properly may cause
chimney to jam and fail to raise up.
By hand:
Note: You can use a degreaser if soiling is stubborn. You
can order it via the online shop.
•
Soak the grease filters in hot soapy solution using a
mild detergent.
•
Use a brush for cleaning and then rinse the filters
well.
•
Allow the grease filters to drip dry.
Clean and dry intake housing, then reinstall or replace
filters before using downdraft.

Clean intake housing:

•
Pull front panel up and out.
•
Remove both filters.
•
Use a mild detergent. DO NOT USE ABRASIVE
CLOTH, STEEL WOOL PADS, OR SCOURING
POWDERS.
•
Clean and reinstall or replace both filters and install
front panel before using downdraft.
NOTICE: The use of brand names is intended only to
indicate a type of cleaner. This does not constitute an
endorsement. The omission of any brand name cleaner
does not imply its adequacy or inadequacy. Many
products are regional in distribution and can be found
in the local markets. It is imperative that all products
be used in strict accordance with instructions on the
package.
NOTE: Do not use cooktop while hood is disassembled.

Cleaning agents

To prevent various surfaces from becoming damaged
due to incorrect cleaning agents, follow the specifications
given in the table. Do not use:
•
cleaning agents that are harsh or scouring,
•
cleaning agents with high alcohol content,
•
hard scouring pads or sponges,
•
high-pressure cleaners or steam cleaners.
Rub stainless steel finishes in the direction of the grain.
Wipe area dry to avoid water marks.
After cleaning, place all parts in their proper positions
before using.
Thoroughly rinse all new sponges before use.
Observe all instructions and warnings accompanying
cleaning agents.
Area Cleaning agents
Stainless steel Warm soapy water:
Clean with a dish rag and dry with a
soft towel.
Only clean stainless steel with the
grain.
Specific products for stainless steel
care are available from customer
service or from specialized retailers.
Apply a thin layer of the care product
with a soft cloth.
Varnished Warm soapy water:
surfaces Clean with a damp dish rag and dry
with a soft towel.
Do not use stainless steel cleaner.
Aluminum and Glass cleaner:
plastic Clean with a soft cloth.
Glass Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Controls Warm soapy water:
Clean with a damp dish rag and dry
with a soft towel.
Risk of damage to electronics due
to moisture penetration. Never clean
controls with a wet cloth.
Do not use stainless steel cleaner.
11