Installation With Gas Cooktops; Prepare Downdraft Housing; Optional: Electrical Panel Can Be Mounted In A Remote Location - Bosch HDD80050UC Instrucciones De Instalación

INSTALLATION

Installation with Gas Cooktops

Dimension "BT" is thickness of
the backsplash that provides
1/2" (13mm) clearance
between the vent and the
backsplash. Any backsplash
with a curved radius where it
meets the counter will require
additional clearance. Thicker
backsplashes may be used
by increasing the counter and
cabinet depths.
Set the cooktop into the
coutertop opening so that
the back edge of the cooktop
overlaps the leading edge of
the downdraft.

Prepare downdraft housing

1. Place the downdraft on its back on a table or fl at work
surface.
SUPPORT
LEGS
2. Slide upper support brackets into slide channel at top
left and right of unit.
Attach long or short support legs (depending upon
cabinet height) to bottom sides of unit with hex screws
provided. Do not tighten hex screws completely at this
time.
English 14
SLIDE
CHANNEL
UPPER
SUPPORT
BRACKET
HEX SCREW
1/4-20 X .500 (12.7MM)
Optional: Electrical panel can be
mounted in a remote location.
Example: There is a drawer
at the bottom of the
cabinet, in front of the
downdraft. This
may require the
electrical panel
to be mounted in
an adjacent cabinet.
If blower discharge is
down, electrical panel
must be relocated.
1. Remove (2) #8-32 hex nuts and
electrical panel. Do not mount with electrical panel slots
facing downward.
2. Installation of a remotely located electrical panel may
be completed after connecting the ductwork and install
the blower. Install electrical panel according to local
codes.
Note: Interconnect
cable may be
unplugged (as shown)
if it helps in routing
of cables for remote
installation of electrical
panel.
INTERCONNECT CABLE (5-FT. (1.5 M) LONG)
Measurements in inches (mm).
#8-32 HEX
NUTS