Maintenance - Greencut PP650X Manual De Instrucciones

62
WORKING TECHNIQUES
• Relaxation cut: To prevent tree bark detachment, recoil tension, or sword pressure when cutting thick branches,
first make a strain cut at the bottom of the branch. To make this cut, place the attachment by pushing it towards
the bottom of the branch until it reaches the tip of the sword. Make the cross cut.
• Flush cut of thick branches: If the diameter of the branch is greater than 10 cm, cut first at the bottom and
make a cross-section at a distance of about 25 cm from the final cut. Then make the cut flush, starting with a
strain cut and ending with the cross cut.

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any
maintenance or repair. This will eliminate any potential risk.
PERIODIC MAINTENANCE
MAINTENANCE
Check for loose bolts/
nuts
Tighten all bolts and
nuts
Fuel filter cup (if
equipped with it)
Air filter
Fuel filter (if
equipped)
Spark plug
Cleaning/Purging the
fuel tank
Fuel line
Blades/Chain (parts
with blades)/Chain
only
Adjusting the idle
speed
Motor adjustment
EACH
EACH
MONTH OR
USE
15H USE
Check
Check
Check
Check
Check
EACH EACH
3 MONTHS OR 6 MONTHS OR
30H USE 60H USE
Realize Replace
Clean/Replace if necessary
Check Replace
Check Replace
Realize Replace
Clean/Replace if necessary
Clean/Replace if necessary
Check
EACH
12 MONTHS OR
100H USE
Adjust