F8-5
F8-6
F8-7
30
English
8. Operation
NOTE
When restarting immediately after stopping the engine,
Ieave the choke knob at the open position.
5. While holding the saw unit securely on the ground,
pull the starter rope vigorously. (F8-5)
WARNING
Do not start the engine while hanging the chain
saw with a hand. The saw chain may touch your
body. It's very dangerous.
6. When firing occur, push in the choke knob and pull
the starter again to start the engine.
7. Allow the engine to warm up with the throttle lever
pulled slightly.
■ CHECKING OIL SUPPLY
WARNING
Make sure to set up the bar and the chain when
checking the oil supply.
If not, the rotating parts may be exposed. It is very
dangerous.
After starting the engine, run the chain at medium
speed and see if chain oil is scattered oft as shown in
the figure. (F8-6)
NOTE
The oil tank should become nearly empty by the time
fuel is used up. Be sure to refill the oil tank every time
when refueling the saw.
■ STOPPING ENGINE
1. Release the throttle lever to allow the engine idling
for a few minutes
2. Put the ignition switch to the "O" position. (F8-7)
NOTE
In case of emergency, turn off the switch without idling
the engine.