RIDGID R4222 Manual Del Operador página 36

OPERATION
CUTTING WARPED MATERIAL
See Figures 51 - 52.
When cutting warped material, always make sure it is
positioned on the miter table awith the convex side against
the fence as shown in figure 51.
If the warped material is positioned the wrong way as shown
in figure 52, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid kickback and serious personal injury, never
position the concave edge of bowed or warped
material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 53.
When cutting wide workpieces, such as a nominal nominal
2 in. x 12 in., boards should be clamped with a work clamp
as shown in figure 53.
RIGHT
Fig. 51
36 - English
WRONG
Fig. 52
WIDE
BOARD
Fig. 53