Extremis MARINA COMBO Instrucciones De Montaje página 6

ASSEMBLY MARINA COMBO
4. Now screw the adjustable feet into the legs. Repeat step
1 through 4 for each table leg assembly and put them
aside.
2. Slide the bench supports onto the table legs.
4. Now screw the adjustable feet into the legs. Repeat step
1 through 4 for each table leg assembly and put them
aside.
6 assembly marina combo
3
1. Insert the table legs into the tabletop connection,
aligning the 3 holes, and use 12 M6 x 16 hexagon
socket bolts and 12 lock nuts to fasten them. First push
all the bolt shafts through the holes and make sure that
the bolts are on the outside. Then thread the nuts onto
the shafts of the bolts and tighten them firmly.
3. Slide the bench connections onto the table leg and the
bench support. First push 12 M6 x 16 hexagon sockets
bolt shafts through the pre-drilled holes. Make sure
that the bolts are on the outside. Only then thread the
nuts onto the shafts of the bolts and tighten them
firmly!
1. Put the 5/6 tabletop profiles on the floor, with the slots
facing upwards, and make sure that the crosses are
facing the same way. Insert a spacer between each
profile at +/- 40 cm from the end.