Assembly Floor Fastening - Extremis MARINA COMBO Instrucciones De Montaje

ASSEMBLY FLOOR FASTENING

B2
B B1
B2
1. Mark the spot on the ground where you want to put the table. There are two anchor points per leg frame (see
diagram above).
L = distance between the legs
B = width of the leg frame
B (5 profiles) = 1100,50 mm
B (6 profiles) = 1245,50 mm
B1 (5 profiles) = 620 mm
B1 (6 profiles) = 765 mm
Attention! If the floor fastening set
was ordered later, it is likely that the
nuts are still in the legs.
8 assembly floor fastening
L
B
B2 (5 profiles) = 240,25 mm
B2 (6 profiles) = 240,25 mm
Drill the nuts out of the legs with
a ø12 drill. Now continue with the
next steps.
L
L
L = distance between the legs
2. Use an electric drill to drill 12 mm
diameter holes on the spots you
marked and insert a 12 x 60 plug
in each hole.