Before Use; Operation - cecotec HidroBoost 1400 EasyMove Manual De Instrucciones

rating equal to or more than the rating of the machine. Do
not use damaged extension cords. Examine extension cord
before using and replace it if damaged. Do not pull from the
cord to disconnect it. Keep the cord away from heat and sharp
edges. Always disconnect the cord from the receptacle before
disconnecting the machine from the extension cord. Make sure
it is connected by means of a cord reel which keeps the socket
at least 60 mm above the ground.

3. BEFORE USE

NOTE: Make sure all the product components are included in the package and they are all in
good conditions. In any of the parts are missing or present visible signs of damage, contact
immediately the official Technical Support Service of Cecotec.
• Attach the high-pressure hose to the pressure water outlet of the machine.
• Attach the spray handle to the high-pressure hose. Prior to operating the machine please
ensure that the high-pressure hose has been completely uncoiled. Whilst the machine is
in operation the hose must not loop.
• Install the pulverizing nozzle or any other equipment you want to use.
• Connect the machine to the water and power supplies.

4. OPERATION

ADJUSTING WATER STREAM
The angle of the water jet coming out of the nozzle may be adjusted
with the pulverizing nozzle by rotating the tip. This will vary the
water pattern from approximately a 0° narrow high-impact stream
to a 60° wide fan spray.
This appliance offers 3 modes:
FOCUSED MODE
The angle of the water jet coming out of the nozzle may
be adjusted with the pulverizing nozzle. Turn the nozzle to
select the focused stream, which has a high impact on the
cleaning surface and results in maximum deep cleaning in
a concentrated area. This narrow high-impact stream must
be used cautiously, as it may damage some surfaces.
HIDROBOOST 1400 EASYMOVE
ENGLISH
21