ENGLISH
CLEANING PROCESS
1.
Surface preparation
Clean the area of furniture and make sure all windows and doors are closed tight. Also, make
sure that all plants and trees near the cleaning area are protected by a drop cloth.
2.
Initial high-pressure rinse
Spray the cleaning surface with water to clear off any dirt or grime that may have collected
on the surface. Before triggering the gun, adjust the pulverizing nozzle to a wide stream and
slowly adjust it to the desired stream. This will avoid applying too much concentrated spray to
the surface which could cause damage.
3.
Final rinse
Start the final rinse at the bottom and work upward. Make sure the surface is thoroughly
rinsed and that al dirt is removed.
4.
Shut down
•
Turn the motor off.
•
Turn the water supply off.
•
Once the power and water supply are turned off, press the trigger to depressurize the
device.
WARNING:
•
Do not turn the water supply off before turning the motor off. Serious damage could occur
to the pump and or motor.
•
Do not disconnect the high-pressure hose from the machine while the device is
pressurized. To depressurize, turn motor off, turn water supply off and squeeze gun
trigger 2-3 times.
TIPS FOR EXTENDING THE PRODUCT'S SERVICE LIFE
•
Never operate unit without water.
•
Do not use the device with hot water.
•
Before adjusting the pulverizing nozzle's pressure (high-to-low or low-to-high) release
trigger.
•
Never operate.
5. CLEANING AND MAINTENANCE
•
The machine shall be disconnected from its power source by removing the plug from the
24
HIDROBOOST 1400 EASYMOVE