Unpacking And Removing Shipping Material - LG WM9500H-A Serie Manual Del Propietário

Concrete flooring is best, but a wood floor is
sufficient, provided it is built to FHA standards.
• The floor under the washer must not slope more
than 1 inch (2.5 cm) from front to back or side to
side.
• Installing on carpeting and soft tile surfaces is
not recommended.
• Never install the washer on a platform or weakly
supported structure.
Floor Installation
To ensure sufficient clearance for water inlet
hoses, drain hose and airflow, allow minimum
clearances of at least 1 inch (2.5 cm) at the sides
and 4 inches (10 cm) behind the washer. Be sure
to allow for wall, door, or floor moldings that may
increase the required clearances.
A
C
B
Dimensions and Clearances
A 23 7/16'' (59.4 cm)
B 56 5/16'' (140.5 cm)
C 32 15/18'' (83.4 cm)
D
E
F 29 5/8'' (75.2 cm)
G
Stacking or Pedestal Installation
The washer can be stacked on top of a pedestal or
pedestal washer.
C
B
A
G
E F E
D
4'' (10 cm)
1'' (2.5 cm)
6'' (15 cm)
D
Dimensions and Clearances
A 34 1/16" (86.5 cm)
B
C
D
NOTE
• Refer to the instructions packaged with the
optional pedestal kit before stacking appliance
on pedestal.
• Do not use a drain pan with a pedestal or
pedestal washer installation as it can block the
drawer. Using a drain pan may result in
increased vibration and noise during operation.
Unpacking and Removing
Shipping Material
Remove all shipping materials from the washer for
proper operation and inspect it for shipping
damage.
CAUTION
• Failure to remove shipping materials can cause
excessive noise and vibration.
Unpacking Shipping Material
* This feature is only available on some models.
Lift the washer off the foam base.
• After removing the carton and shipping
material, lift the washer off the foam base.
• Make sure the plastic drum support
off with the base and is not stuck to the bottom
of the washer.
• If you must lay the washer down to remove the
carton base , always protect the side of the
b
INSTALLATION
4'' (10 cm)
6'' (15 cm)
52'' (134 cm)
* comes
a
11