LG WM9500H-A Serie Manual Del Propietário página 24

24 OPERATION
• These buttons allow you to select additional cycle options. Certain buttons also allow you to activate
special functions by pressing and holding the button for 3 seconds.
Time and Status Display
Cycle Status Indicators
a
• These LEDs will blink when a cycle is selected to indicate which stages will run.
• When a cycle is running, the LED for the active stage will blink, and the LEDs for the remaining stages
will remain steady. Once a stage is complete, the LED will turn off. If a cycle is paused, the active stage
LED will stop blinking.
Estimated Time Remaining
b
• When a cycle is selected, the default time for that cycle is displayed. This time will change as modifiers
or options are selected.
• If the display shows
size.
• The time shown is only an estimate. This time is based on normal operating conditions. Several
external factors (load size, room temperature, incoming water temperature, etc.) can affect the actual
time.
NOTE
• Once the Start/Pause button is pressed, the washer will measure the size of the load. The estimated
time may change once the load size has been measured.
• If the Delay Wash function is set, the remaining delay time counts down until the cycle begins.
Door Lock Indicator
c
• This indicator lights up when the cycle starts and the door is locked.
• The indicator light stays on until the cycle is paused, stopped or has finished.
Control Lock Indicator
d
• This indicator lights up when the control panel is locked.
• and the remaining wash time are displayed, in turn, on the time remaining display.
CL
• When this function is set, all controls are disabled except for the Power button.
Fresh Care Indicator
e
• This indicator lights up when the Fresh Care option is selected.
Wi-Fi Indicator
f
• This indicator is lit when the product is connected to a home Wi-Fi network.
Grid Mode Indicator
g
• This indicator lights up when Smart Grid is activated.
Remote Indicator
h
• This indicator lights up when Remote Start is activated.
, then the time will be displayed after the load sensing has detected the load
-I--