Ikegami ICD-48 Manual De Instrucciones página 5

① Lens mount (CS mount)
Accepts many types of CS mount lenses.
② C mount adaptor (Accessory)
Attached to the lens mount to accept many types of C mount lenses.
③ Flange focal distance adjuster
Used to adjust the flange focal distance depending on the type of lens used. Helpful
when the lens' focus ring fails to put into focus.
④ Flange focal distance lock screw
Used to mechanically lock the flange focal distance after fine adjustment of it.
⑤ Holder screw hole
Used to mount the camera onto the camera holder. Effective for general camera tripods.
Note: Be sure to use less than 5.5mm- long setscrew (1/4" – 20 UNC) for mounting
the camera to tripods or holder.
⑥ Lens selector switch
Used to choose between the video iris and the DC iris depending on the type of auto
iris lens used.
⑦ Auto iris lens connector
Specifically used to connect the auto iris lens. Use the connector plug that is attached
to the camera.
• For the video type auto iris lens
Set the lens selector switch to VIDEO position.
— Connector cable leads —
1. Red (power)
2. Not used
3. White (video)
4. Black (shielded)
* Dress the tip of the green lead to prevent a short-circuit.
• For the DC type auto iris lens
Set the lens selector switch to DC position.
— Connector cable leads —
1. Damping coil (-)
2. Damping coil (+)
3. Driving coil (+)
4. Driving coil (-)
* Connect the leads as shown above.
Refer also to the instructions of the lens.
2 4
3
1
4
2
3
1
3
1
Numbers of connector pins
E-3
Auto iris lens
Auto iris lens
4
2