Door Control - Craftsman SMART CONTROL Manual Del Propietário

Abridor de la puerta de cochera inteligente
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Door Control

SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press
the push bar until the garage door opener activates (it may take
up to 3 presses). Test the door control by pressing the push bar,
each press of the push bar will activate the garage door opener.
USING THE DOOR CONTROL
Push Bar
1 Minute,
5 Minute,
and 10
Minute TTC
LED
Push Bar
Press the push bar to open or close the door.
Light Button
Press the LIGHT button to turn the garage door opener lights on
or off. When the lights are turned on they will stay on until the
LIGHT button is pressed again, or until the garage door opener is
activated. Once the garage door opener is activated the lights will
turn off after the specified period of time (the factory setting is 4-
1/2 minutes). The LIGHT button will not control the lights when
the door is in motion.
The duration of the light timing can be adjusted using the door
control.
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry, or Smart
Control accessories can be programmed to the garage door
opener by pressing the LEARN button on the Motion-Detecting
Control Panel.
Lock
The LOCK feature is designed to prevent activation of the garage
door opener from remote controls while still allowing activation
from the door control and keyless entry. This feature is useful for
added peace of mind when the home is empty (i.e. vacation).
Timer-to-Close (TTC)
DO NOT enable TTC if operating a one-piece door. TTC is to be
HOLD Button for
the Timer-To-Close
used ONLY with sectional doors.
(TTC)
Factory default is set to off. TTC can be set to automatically close
your garage door from the fully open position after a specified
LIGHT
period of time (1, 5, 10 minute intervals). The garage door opener
Button
will beep and the lights will flash before closing the door. If the
door encounters an obstruction while closing, the garage door
opener will make a second attempt to close the door. If the
Motion
Sensor
obstruction has not been cleared after the second attempt, the
garage door opener will reverse open, stop and WILL NOT close
until the obstruction has been cleared. TTC WILL NOT work if the
garage door opener is operating by battery power or if the safety
reversing sensors are misaligned. This feature is NOT intended to
be the primary method of closing the door. A keyless entry
should be installed in the event of an accidental lock out
when using this feature.
AUTOMATIC LIGHT
Motion Sensor
Factory default is set to on. This feature will automatically turn on
the garage door opener lights when motion is sensed. The lights
will come on for the set period of time, then shut off.
If using the garage door opener light as a work light disable the
Automatic Light Feature, otherwise the light will turn off
automatically if you are beyond the range of the sensor.
Light Feature
The lights will turn on when someone enters through the open
garage door and the safety reversing sensor infrared beam is
broken.
37

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

139.57918

Tabla de contenido