Greencut GM560L-4 Manual De Instrucciones página 65

2
PRUNER INSTALLATION
For mounting the accessory to a power unit:
1. Make sure the lock is not tightened.
2. Align the pin with the arrow mark.
3. Insert the shaft into the drive shaft of the power head, the release button comes off.
4. Tighten the locking nut firmly as shown.
5. To remove the accessory, loosen the lock lever, press the lock button and remove the shaft.
ATTENTION: Do not tighten the lock without the accessory shaft inserted. Otherwise, the locking
lever may overtighten the drive shaft input and damage it.
A
1
B
C
D
B
A
3
A
4
C
65
EN
B