Product Use - Greencut GM560L-4 Manual De Instrucciones

TO ADJUST THE TENSION OF THE SAW CHAIN
1. Loosen the retaining nuts on the bar so that they are tightened by hand.
2. Hold the tip of the bar upwards, use the screwdriver to turn the adjusting screw on the guide bar clockwise
(to the left) to tighten the chain. Turning the screw counterclockwise (clockwise) loosens the chain on the
guide bar.
3. After you have made the adjustment, move the saw by chaining the chain back and forth on the guide bar
to ensure that the chain moves freely and is in the proper sprocket/wheel mesh. Never move the chain with
unprotected hands or without gloves.
ATTENTION: If the chain is difficult to turn or if it is attached to the guide bar, there is too much
tension and has to be readjusted. To decrease the tension, slowly turn the adjusting screw
counterclockwise (clockwise). Move the chain back and forth until it moves freely.
4. Hold the nose up, tighten the bar retaining nuts firmly.
OIL THE CHAIN
The saw chain is self-lubricating. The oil is spread over the chain as it is used. Make sure that there is an adequate
amount of oil in the oil tank. Always use chain and sprocket oil or similar saw chain oil.
HEDGE TRIMMERS
To enhance the added value of the tool, this product can be coupled without any hassle:
1. Mount the hedge trimmer accessory with the cylinder head shaft (refer to the assembly instructions in the manual).
2. Refer to the operating instructions in the user manual for operation.
READINESS FOR OPERATION
For ease and safety of operation, your hedge trimmer should be coupled with the loop
handle. For the most appropriate cut for the area you are cutting, you can adjust the
blade angle based on the practical adjustment of the situation as follows: Press A & B at
the same time and then adjust the blade angle. After adjustment, release A & B.

PRODUCT USE

START UP
A
B
1 1
A
2
B
67
EN