Isotronic Diamant Instrucciones De Uso página 11

Installation suggestion (see drawing):
Place the repeller in such a position that animals will have the possibility to flee
from your land. After about 5-6 weeks the device/s should be moved
approximately 4-5 metres in the direction of the escape route.
ATTENTION: Never stick the device directly into the hill. If you are using
several devices, never install them in the corners of the plot; you then
contain the animals in the middle and block their possible escape routes.
Start repelling the animals directly at the house and work your way toward
the property boundaries. In very dry and hard soil, drill a hole in the ground
and compact the soil around the rod. Look out for underground barriers,
such as pipes, foundations, edges and borders, and concrete slabs! These
barriers reduce the spreading of the frequency waves and their
effectiveness.
3. Replacement of the rechargeable battery
1. Remove the transparent housing cover.
2. Carefully take off the solar panel from the rechargeable battery which is
underneath. When doing so, make sure that the cable connection between the
solar panel and the circuit board which is underneath the rechargeable battery,
is left intact and is not damaged.
3. Remove the old rechargeable battery from its fitting.
4. Insert a new rechargeable battery size Mignon (AA) and type Ni-MH with 1.2 V
and 850 mA. When doing so, mind the correct polarity as shown on the bottom
inside the battery fitting.
5. Carefully place the solar panel back on the rechargeable battery. Pay attention
that the two cable of the solar panel will not conducted above the batteries for
closing the casing in the right way.
6. Reattach the transparent casing cover to the casing body.