Panasonic WH-ADC0309J3E5C Manual De Instrucciones página 11

Remove The Remote Controller From Tank Unit
1. Remove the top case from the bottom case.
/
2. Remove the wiring between Remote controller and Tank Unit
terminal.
Disconnect the
Remote controller
wiring
Mounting The Remote Controller
For exposed type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Connect the remote control
wiring
•
Arrange the wires along the groove
of the case.
Insert the
driver and
slightly turn.
Bottom
case
Claw
(2 places)
Mount the bottom case to
the wall.
Cut here with
a nipper and
remove the burr
with a fi le.
U P
Claw (2 places)
Wall to which
the remote
controller is
fi xed
Hole for screw
Claw (2 places)
Screw
(fi eld supply)
Clamper
(fi eld supply)
Pass through
the hole
Remote controller terminal board
Remove the coating. Approx. 6 mm
Top case
(Back side)
Bottom case
(Back side)
Remove the sheath. Approx. 180 mm.
Make sure the wiring connection is in the
correct direction.
For embedded type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Flat-blade
screwdriver
Connect the remote
control wiring
Replace The Remote Controller Cover
•
Replace the existing Remote controller cover with Remote controller
cover 5 to close the hole left after remove the Remote controller.
1. Release the Remote controller cover's hooks from behind the
Front Plate f.
Existing Remote
controller cover
2. Press from front to fi x the Remote controller cover 5 on the front
plate.
Mount the bottom case
to the wall.
•
Pass the wire through the hole
in the centre of the bottom case.
Avoid the wire
being caught.
U P
Claw (2 places)
Hole for
screw
Claw (2 places)
Screw
(fi eld supply)
Top case
(Back side)
Bottom case
(Back side)
f
Front Plate
Hook (6 places)
f
Front Plate
Remote
Hook (6 places)
controller
cover 5
Remote controller
terminal board
Remove the coating.
Approx. 6 mm
Make sure the wiring
connection is in the correct
direction.
11