Delta 31-735 Manual De Instrucciones página 11

INSTALLING THE BELT ON THE MOTOR
Disconnect the machine from the power source!
1. Remove the two screws (A) Fig. 15 from the top of the sanding unit and remove the plate (B).
2. Check to see that the belt (C) Fig. 16 is in the groove of the pulley (D) of the sanding unit.
3. Lift the motor (F) Fig. 17 and place the belt (C) on the motor pulley (G).
4. Slowly lower the motor (F) Fig. 17 to apply pressure to the belt (C).
5. Secure the motor with the hex nuts (H) Fig. 18.
F
INSTALLING THE DUST CHUTE
Disconnect the machine from the power source!
1. Insert the dust chute (A) Fig. 19 through the inside
hole of the cabinet back panel (B) that was removed
earler.
2. Align the four holes in the dust chute (A) Fig. 19 with
the four holes in the back panel (B). Insert an M4-
0.7 x 12mm sheet metal screw through the back
panel (B). Thread the screw into the dust chute.
Tighten securely.
3. Repeat for the three remaining holes.
A
B
Fig. 15
C
G
Fig. 17
B
11
D
C
Fig. 16
H
Fig. 18
A
Fig. 19