Assembly - Delta 31-735 Manual De Instrucciones

Máquina para acabados abrasivos con banda de 152 mm (6") y disco de 305 mm (12")
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
ATTACHING THE CASTER ASSEMBLY TO THE MOTOR CABINET
Disconnect the machine from the power source!
1.
Place the motor cabinet on its side.
2.
Align the three holes in the bracket (B) Fig. 1 with the
three holes in the inside of the base (C).
3.
Insert a 3/8-16x1" carriage head bolt through the hole
in the bracket (B) Fig. 1 and through the base (C).
4.
Place the pivot bracket (D) Fig. 2 on the screw and
aligned with the other holes (C).
5. Place a 3/8" flat washer on the screw. Thread a 3/8-16
hex nut on the screw and hand-tighten.
6. Repeat this process for the two remaining holes.
7. Tighten all of the hardware securely.
8. Align the two holes in the caster assembly (E) Fig. 3
with the two holes (F) in the pivot bracket.

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
1/4" Wrench
5/16" Wrench
3/8" Wrench
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 1 to 2 hours.
Adjustable Wrench
Pliers
Phillips Screwdriver
B
C
D
Fig. 2
F
Fig. 3
8
Fig. 1
C
E

Publicidad

Tabla de contenido
loading

Tabla de contenido