Battery Specifications - Shure KSE1500 Guia Del Usuario

Maintenance and Cleaning
Careful maintenance ensures a tight seal between the sleeve and
nozzle, improving sound quality and product safety.
• Keep the earphones and sleeves as clean and dry as possible.
• To clean sleeves, remove them from earphones, gently rinse in
warm water and air dry. Foam sleeves require a longer drying time.
Inspect for damage and replace if necessary. Ear sleeves must be
completely dry before reusing.
• Wipe the earphones and sleeves with mild antiseptic to avoid
infections. Do not use alcohol-based disinfectants.
• Do not expose earphones to extreme temperatures.
• Replace sleeves if they do not fit properly.
• Do not attempt to modify this product. Doing so will void the warranty
and could result in personal injury and/or product failure.
Cleaning the Earphone Nozzle
If you notice a change in sound quality, remove the sleeve and check
the nozzle of your earphone. If nozzle is blocked, clear obstruction by
using wire loop end of cleaning tool.
If no obstruction is found or if sound quality does not improve, replace
the sleeve with a new sleeve.
Cleaning Tool
Caution: When cleaning, do not force any object through the earphone nozzle!
This will damage the earphone sound filter.
Warning: The cleaning tool is only to be used to clean the earphones. Any
other use, such as using the tool to clean ears or foam sleeve, could result
in injury.
Wire Loop
Specifications
Kit Specifications
Bias Voltage
200 V DC
Output Voltage
±200 V, max.
Output Current
≤ 1 mA
Noise Attenuation
≤ 37 dB
Operating Temperature Range
0 to 45°C (32 to 113°F)
Storage Temperature
-18 to 57°C (0 to 135°F)
Earphone Specifications
Transducer Type
Electrostatic
Connector Type
Lemo Connector
Frequency Response
10 Hz to 50 kHz
Maximum SPL
113 dB SPL (1 kHz at 3% THD)
Net Weight
44.0 g (1.55 oz.)
Amplifier Specifications
Bit Depth
16-bit / 24-bit
Sampling Rate
44.1 / 48 / 88.2 / 96 kHz
Signal-to-Noise Ratio
up to 107 dB A-weighted
Adjustable Gain Range
-40 dB to +60 dB
Limiter
Selectable Analog RMS Limiter
Equalizer
4-band Parametric
USB Input
USB Micro-B Receptacle
Line-In Input
3.5 mm (1/8")
Charging Requirements
USB-powered: 5 V/0.5 A to 1 A
Housing
Black Anodized Aluminum
Net Weight
182.0 g (6.42oz.)
Dimensions
111 x 59 x 21 mm H x W x D

Battery Specifications

Battery Type
Rechargeable Li-Ion
Nominal Voltage
3.6 V DC
Battery Life
Analog in (BYPASS up to
EQ) 10 hours
USB Input (Analog up to
EQ mode) 7 hours
5