Husqvarna TE 250 2012 Caracteristicas - Uso - Mantenimiento página 108

REPLACING THE NUMBER PLATE LAMP (TE)
- loosen screw (1) and remove the number plate bulb (2) from
the mudguard;
- take bulb holder (3) and bulb (4) out of the support;
- pull the bulb (4) to detach it from bulb holder.
Once the bulb has been replaced, reverse the above procedure
to reassemble.
1
EN - 52
SPECIFICATIONS - OPERATION - MAINTENANCE
ADJUSTMENT OF HEADLIGHT (TE)
When checking the proper orienting of headlight, inflate tires
at right pressure, sat a person on the saddle and place the mo-
torcycle perpendicular with its longitudinal axis 10 meter (33
ft) from a wall or screen. Then trace an horizontal line equal to
the height of headlight center and a vertical one in line with its
longitudinal axis.
If possibile, execute this operation in a shadowy place.
When the low beam is on, the upper boundary limit between
dark and lit zone should be 9/10 th of headlight center from
groud.
2
3
4
Adjust the preadlamp aiming by turning screw (1) to lower or
lift the high beam.
1