REVELL Control BUGGY ZIP Manual De Instrucciones página 8

1A Steering Servo
1B 2n1 ESC/Receiver Unit
1C On/Off Switch
Remote Control
3A Insert 4 „AA" batteries according to the polarity indication in
the battery compartment of the transmitter.
The charging process lasts approx. 7 hours. Unplug the battery when charge is complete.
CHARGE MONITOR
Green
Red "On"
Red "Off"
4A Install the battery into the vehicle and connect the battery.
Mount the bridge of the battery mount and secure the battery bridge at the front and rear with bodywork clamps.
4B Switch on the remote control.
4C Switch vehicle on.
5A Throttle Trim:
If the vehicle rolls forward without throttle input, rotate the throttle trim knob slightly left. If the vehicle rolls backwards
without throttle input, rotate the throttle trim knob slightly right.
5B Steering Trim:
If the vehicle tracks right (when viewed from behind), rotate the steering trim knob slightly left. If the vehicle tracks left
(when viewed from behind), rotate the steering trim knob slightly right. Check that the servo saver screw is fully tightened
to ensure that your vehicle tracks straight.
5C Throttle Dual Rate:
I f you need to limit the maximum speed of your vehicle, rotate the "TH.D/R" knob counterclockwise. For higher top speeds,
rotate the knob clockwise.
5D Steering Dual Rate:
If you need to limit the amount of steering your vehicle has, rotate the "ST.D/R" knob counterclockwise. For more steering,
rotate the knob clockwise.
6 CONNeCTINg The MOdel TO The reMOTe CONTrOl
1. First switch on the remote control, then the model (vehicle).
2. P ress the "SW" button on the 2n1 ESC/Receiver unit and re-
lease. The ESC should beep, notifying you it is linked.
3. Process is complete.
8
1 VehICle
1D M370 Motor
1E Battery Connector
1F NiMH Battery
3 INSerTINg BaTTerIeS
LED INDICATORS
Power ("ON" at all times)
Battery is charging
Charging is complete
4 START PREPARATION
5 TrIMS aNd dual raTeS
2 reMOTe CONTrOl
2A Throttle Trim
2B Steering Trim
2C Radio Battery Indicator
2D Throttle Dual Rate
2E Steering Dual Rate
Modell
3B Switch off the vehicle and remove the battery.
3C Carefully connect the battery to the charge monitor.
3D Plug the monitor into the charger and the charger into
an AC wall outlet.
7 VehICle CONTrOl
7A To slowly drive forward, pull the trigger slightly. To drive
faster, pull the trigger further.
7B To brake, push the trigger. To drive in reverse, push again.
During a crash, release the trigger.
7C To turn, rotate the wheel to the left or right. Adjust the
steering trim if the car doesn't track straight (see below).
Achtung:
· When the vehicle battery becomes low, the vehicle will start to
slow down.
· Allow the battery to cool before recharging.
· Make sure to turn both the vehicle and the radio off
after each use.
· ALWAYS unplug the battery after each use.
2F ON/OFF Switch
2G Throttle lever
2H Steering wheel
2I Steering channel reversal
2J Throttle channel reversal