ESYLUX PD-C360i/8 UC Manual De Instrucciones página 14

Setting the time setting
Setting is only possible if it has not already been carried
out by the programmable logic controller.
2 x 15 min = 30 min
If no movement is detected, the time setting starts.
3 x 15 min = 45 min
GB LED acknowledgement:
4 x 15 min = 60 min
up to 10 min = red/blue flash alternately
15 min = 1 x blue LED
30 min = 2 x blue LED
45 min = 3 x blue LED
60 min = 4 x blue LED
Switch between fully automatic and semi-automatic mode
for light channel
For semi-automatic mode, the blue LED turns off for
approximately 2 seconds.
For fully automatic mode, the blue LED flashes 3
times.
Switch LEDs oN/oFF (red/green LED)
To switch LEDs off = press button, the blue LED will
turn off for approximately 2 seconds.
To switch LEDs on = press button, the blue LED will
flash 3 times.
Restore factory settings
Confirmed by brief alternate flashing of the blue and
red LEDs on the detector.
14
Configuration of the floating output
open the service menu
The key combination must be pressed
within 5 seconds.
Make contact/lighting oN in start-up phase
1 x
Indicated by 1 flash of the blue LED.
Make contact/lighting oFF in start-up phase
2 x
Indicated by 2 flashes of the blue LED.
Break contact/lighting oN in start-up phase
3 x
Indicated by 3 flashes of the blue LED.
Break contact/lighting oFF in start-up phase
4 x
Indicated by 4 flashes of the blue LED.
Close the service menu