Hose & Regulator Specifications And Installation - Signateur 1500131 Instrucciones De Ensamble Y Cuidado

LP GAS CYLINDER (TANK) RUBBER SEAL INSPECTION:
• Inspect the propane tank valve rubber seal for cracks, wear or deterioration
prior to use. A damaged rubber seal can cause a gas leak, possibly resulting
in an explosion, fire or severe bodily harm.
• Inspection should be done each time the propane tank is connected to the
grill, has been refilled, exchanged or has not been used for more than 60 days.
• Do not use a propane tank with a damaged rubber seal. Exchange the tank or
have the rubber seal replaced at a qualified propane filling station.
INSTALLING THE LP GAS CYLINDER (TANK) ONTO THE GRILL:
1. Check that the cylinder valve is closed by turning the knob clockwise. Inspect cylinder valve rubber seal for cracks or deterioration.
Do not use propane tank with damaged seal as a gas leak may occur.
2. Place the cylinder into the tank holder in the bottom of cabinet.
3. Orient the cylinder such that the valve opening faces the right side of the grill, and the hose is not kinked or damaged.
4. Fully tighten the tank retention screw on the back side of grill to secure tank.
HOSE & REGULATOR SPECIFICATIONS AND INSTALLATION:
• For dual fuel grills that can be converted to natural gas, a universal conversion kit (sold separately) can be purchased at most
hardware or lawn & garden patio retailers.
• DO NOT use any other pressure regulator/hose assembly other than the one supplied with your grill.
Replacement pressure regulator/hose assembly must be part No. 1500111-0003, which can be obtained by contacting
Customer Service Call: 1-866-305-4414 (English only) Mon-Fri 6AM to 2PM PST or send us email at support@signateur.com
• DO NOT attempt to adjust or repair a regulator. The regulator is designed to operate at a maximum output pressure of
27.94 cm/11 in of water column.
• The pressure regulator and hose assembly supplied with the outdoor cooking gas appliance must be used.
Replacement pressure regulators and hose assemblies must be those specified by the outdoor cooking gas appliance
manufacture.
• Ensure the tank valve is CLOSED prior to connecting the LP gas cylinder to your grill. Turn the valve knob clockwise to
properly close the valve. Read and follow all instructions and warnings on the supply hose safety tags. Read and follow all
warnings in this manual concerning the safe use of LP gas cylinders and the hose and regulator before connecting cylinder
to grill. Read and follow all warnings on the LP cylinder.
5
Tank Retention Screw
WARNING
Good Damaged
Rubber Seal Rubber Seal