Cycle Programming; Displaying A Cycle In Memory; Displaying Individual Cycle Usage - Alliance Laundry Systems SF135PV Manual De Instrucciones

Programming

Cycle Programming

Displaying a Cycle in Memory

1. Locate the key-operated programming switch:
On 135-pound models, the Program Mode
G
switch is located behind an access door
directly below the emergency stop button (top
right on the front panel of the washer-
extractor).
On 250-pound models, the Program Mode
G
switch is located on the back side of the
computer access door (left side of front panel
of the washer-extractor) below the computer
board.
Insert the key and turn the switch to the
PROGRAM position. The display will read
"CYC00".
2. Press the Edit Cycle key on the keypad. The
display will read "DCYC00".
3. Press the two-digit code to display the desired
cycle number: For example, press key 2 and then
key 5 to select cycle 25. The display will read
"DCYC25".
4. Press the Enter key. The computer will search for
cycle information for this cycle number.
If no cycle information exists, the computer will
flash "NCYC25" followed by "ADD?". To add
this cycle, press the Enter key and proceed to the
Add Cycle programming mode. If adding this
cycle is not desired, press the Clear key, and the
computer will then return to the normal
programming mode.
5. If cycle information does exist for cycle 25, the
computer will display "0425", for example, to
indicate that cycle 25 has been run four times. To
clear the count (reset it to zero), press key 0. The
display will then show "0025".
If clearing the count is not necessary or if it has
just been cleared, press the Enter key. The
computer will now display "HH0125", indicating
the first step of cycle 25.
44
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
6. Press the Advance key to move to the next step of
the cycle. To access further information
pertaining to each step (for example, temperature
and/or time), press the Enter key. If the display
shows a temperature, press the Enter key again to
display the time. Press the Enter key once more
to advance to the next step.
7. At the end of the cycle, the computer will display
"END-25" for two seconds and return to the
normal programming mode.
8. Return the Program Mode switch to the RUN
position and remove the key.
NOTE: Never press the Clear key while displaying
a cycle in memory except to edit or delete a step.

Displaying Individual Cycle Usage

1. Locate the key-operated programming switch:
On 135-pound models, the Program Mode
G
switch is located behind an access door
directly below the emergency stop button (top
right on the front panel of the washer-
extractor).
On 250-pound models, the Program Mode
G
switch is located on the back side of the
computer access door (left side of front panel
of the washer-extractor) below the computer
board.
Insert the key and turn the switch to the
PROGRAM position. The display will read
"CYC00".
2. Press the Edit Cycle key on the keypad. The
display will read "DCYC00".
3. Press the two-digit code to display the desired
cycle number: For example, press key 2 and then
key 5 to select cycle 25.
F232101