Truper SICI-7-1/4A3 Manual De Instrucciones página 21

Start Up
Cutting depth adjustment
1. Loosen the cutting depth adjusting knob.
2. Having the base fixed, raise the housing until the disc sticks out to the desired depth from the base. Use the depth guide
as reference.
3. Tighten the cutting depth adjusting knob to prevent the housing from moving during the cut.
4. Cutting depth can go up to 2.5"
CAUTION
• The cutting depth should match the work piece thickness or stick out from the piece the size of one disc
tooth at the most, to prevent causing an accident.
2
Cutting depth guide
3
Base
1
Cutting depth
adjusting knob
Cutting angle adjustment
• Loosen the cutting angle adjustment knobs.
• Fix the base. Turn the housing until the disc sits on the desired angle.
• Tighten the angle adjustment knob to prevent the housing to move during the cut.
• The tool can make cuts from 0° to 45°
Cutting depth
adjusting knob
Parallel guide adjustment
Use the parallel guide to fix the work piece while cutting. To adjust widths loosen the knob and slide the parallel guide into
the desired position.
Parallel guide
adjusting knob
9
ENGLISH