SATA J Serie Manual Del Uso página 18

7） Work light:
Machine is equipped with the work light: when the switch is pressed, the light will come on; when it is released, the light will go out
15s later.
8） Spindle self-locking （see Figure G）:
The spindle self-locking function allows the machine to operate as a hand tool. When the battery pack is exhausted, you can
manually rotate the machine to tighten or loosen the screw. In this case, the chuck is stationary.
9） Battery level display:
When the machine switch is pressed, the battery indicator will come on. The remaining capacity of battery pack may be determined
according to the following table.
10） Drilling operation:
When drilling on the surface of hard material, first mark the area where you want to drill with the pointed punch and hammer
to prevent the bit from slipping. Hold the hand drill, align the bit tip with the mark, and press the switch to drill. Drill with the
appropriate pressure. Do not apply excessive pressure or deviated pressure to increase the diameter.
11） Overload protection:
This machine is equipped with an overload protection system. If the machine keeps overloaded for a long time, the protection mode
will be automatically activated to stop the operation. At this time, you can release the switch. When the machine is restarted, the
overload protection is automatically released and the machine can be used normally, but the workload shall be reduced.
Note:
The intact high-speed steel bit shall be used for the drilling on metal. For the short screwdriver bit, use a magnetic connecting
rod （not included）. When tightening the screw, apply a little soap or other lubricant to the thread to facilitate theoperation.
Question and answer:
1 ） Why does the machine not operate after the switch is pressed?
A reversing yoke is located on the upper part of switch. It is locked. Turn it to the position where the rotation is in need, and then
press the button to rotate the machine.
2） Why does the hand drill stop when the screw has not been tightened?
The machine has low-voltage protection. When the level of battery pack is too low, the machine will not work. Please confirm the
level of battery pack.
The machine has temperature protection. When the battery is working at full load for a long time, the battery pack will overheat and
18
51012
LED display
中文
EN
High-strength drilling
Remaining battery
0-25%
25-50%
50-75%
75-100%
DE RU KO PT JA ES