SATA J Serie Manual Del Uso página 19

the temperature protection system will start to stop the machine. Cool the machine to normal temperature before resumption.
Adjust the torque adjusting ring between the body and chuck. The minimum torque corresponds to position "1", and the maximum
torque corresponds to position "21". Setting the torque adjusting ring to a higher position can solve this problem.
3） Why is the service life of same kind of battery pack is different?
As mentioned above, if a battery pack is left unused for a long time, its service life may be shortened. This is the matter of charging
frequency. Repeated charging and application may improve the situation. In case of heavy work, e.g. When the large screw is driven
into the hardwood, the battery pack will run out soon. Do not charge in a temperature below 0 ° C or above 45℃ . Otherwise, the
performance of battery pack will be affected.
Maintenance:
Be sure to unplug the battery pack before replacing or repairing the machine：
The electric tool does not require additional lubrication or other maintenance. Do not wash the electric tool with the water or chemical
cleaner. Wipe it off with a dry cloth. Tool shall be stored under the dry conditions and kept clean at the vent of motor. Try not to use it in
a dusty environment.
To prolong the service life of battery pack:
1 ） Store the battery pack below 26 ° C after charging it to 30%-50%.
2） Charge the battery pack fully once in less than 6 months.
Disposal of discarded battery pack:
To protect the natural environment, please recycle or dispose of the battery pack properly. The battery pack contains a Li-
ion battery. Please consult the local waste disposal department for the information on recycling and/or disposal. Exhaust the
battery pack with the hand drill, remove the battery pack, and wrap the pole port with strong tape to avoid the short circuit
and leakage. Do not attempt to open or remove any part.
Environmental protection
Disposal of waste:
The damaged machine, accessories and packaging materials shall be classified in detail for recycling in line with environmental
protection requirements.
All plastic parts are marked with material identifications to facilitate the classification and recycling.
51012
中文
EN DE RU KO PT JA ES
19