Publicidad
Idiomas disponibles
Idiomas disponibles
-
Tighten the covers (4) again.
Note: Always replace both carbon brushes at the
same time, never use a mixture of old and new
brushes.
Mounting the dust bag
Fig. 1
Press in the clamp of the dust bag (13) and slide
it onto the opening on the back of the machine.
The dust bag stays in place when you release the
clamp.
4. Operation
Using the mitre saw
Fig. 1
Before use, always check for faults or
defects!
•
Set the desired sawing angle of the machine.
•
Put the plug into the socket.
•
Fix the piece of work in place using the clamp
(7): make sure that the material is well
clamped in place!
•
Hold the material tightly on the left side while
making sure that you keep a safe distance
from the blade of the saw.
•
Turn on the machine using the switch (1).
•
Make sure that the saw blade has reached full
speed before allowing it to touch the piece of
work to be sawn.
•
Use knob (3) to raise the protective cover
lock.
•
Now bring the saw slowly downwards so that
the saw blade saws through the piece of work
and passes through the slot in the table. Do
not put any pressure on the saw. Give the
machine time to saw through the piece of
work.
•
Bring the machine gently up again and switch
it off by letting go of the switch (1).
Using the slide-function
Fig. 1
The machine must be firmly bolted to a
workbench.
Use the slide-function for sawing wide
workpieces:
All manuals and user guides at all-guides.com
•
•
•
•
•
•
•
Using the laser
Fig. 2
•
•
5. Service and maintenance
Slide rails
Dirt can damage the slide rails and thereupon the
operating of the machine.
•
•
•
These machines are designed to function for a
long time without any problems with a minimum of
maintenance. By cleaning the machine regularly
and using it in the correct way you can contribute
to a long life of your machine.
Cleaning
Clean the machine housing regularly with a soft
cloth, preferably after each time you use the
machine. Make sure that the ventilation slots are
free of dust and dirt. For stubborn dirt use a soft
cloth dampened with soapy water. Never use
solvents such as benzene, alcohol, ammonia, etc.
These types of solvents can damage the plastic
parts.
Problem solving
1. The motor does not start
•
Fix the piece of work in place using the clamp
Loosen the knob (12)
Slide the machine completely towards
yourself
Turn on the machine using the switch
Bring the saw slowly downwards so the saw
blade saws through the piece of work
Push the machine slowly backwards
Bring the machine gently up again and switch
it off by letting go of the switch
To switch on the laser , press the on/off switch
2.
To switch off the laser , release the
on/off switch 2.
Always make sure that the machine is
not connected to the mains electricity
when you carry out any maintenance of
the mechanism.
Clean the slide rails regularly with a soft cloth.
Drip some lubricating oil on the slide rails
Move the mitre saw forwards and backwards
so the oil spreads over the complete rails
The plug is not in the socket
EN
11
Publicidad
