Publicidad
Idiomas disponibles
Idiomas disponibles
stop before you take your hands off the
machine.
Safety tips for the laser beamer
•
Never look into the light beam of the laser.
•
Never point the light beam of the laser at
humans or animals.
•
Do not point the light beam of the laser at
strongly reflecting material. Hazard from
reflected light.
•
Only have repairs made to the laser beamer
by qualified personnel / professional repair
specialists.
•
Do not insert any hard objects into the laser
optics.
•
Clean the laser optics with a soft, dry brush.
Motor
•
Connect the machine to a 230 V socket.
•
If the motor does not start, immediately
release the switch. Take the plug out of the
socket. Check that the saw blade can turn
freely. If so, try starting the machine again.
To prevent damaging the motor must be
regularly freed of chips and dust to
ensure correct cooling.
•
If the motor suddenly stops while sawing, let
go of the switch immediately. Loosen the saw
blade from the piece of work, after which
sawing can continue.
•
Using long cables of too small a diameter can
result in loss of voltage, which can lead to
problems with the motor.
•
For a length up to 15 metres a cable must
be used with a diameter of 1.5 mm
•
For a length of between 15 and 40 metres
a cable must be used with a diameter of
2.5 mm
.
2
Turn the appliance off immediately in the event of:
•
A faulty mains plug, mains flex or flex damage.
•
A faulty switch.
•
Smoke or smell from scorched insulation.
•
Seizing of the saw.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
All manuals and user guides at all-guides.com
also the enclosed safety instructions.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
3. Assembly and accessories
Installation of the mitre saw
•
•
•
Note: Never use the mitre saw without the
extension pieces supplied. Make sure that they
are correctly mounted.
Mounting the anti-tip over support.
•
•
Installation of the machine on a workbench or
.
2
on the subframe.
Fig. 5.
This machine is a stationary machine and for
safety reasons must always be firmly installed and
not used for mobile applications.
You can install the machine in two ways:
a. As a stationary machine on a workbench. In
b. As a stationary machine on the subframe.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Class ll machine. Your machine is
double insulated; therefore no earthwire
is required.
Place one sidebar (21) on the right-hand side
of the machine and the other sidebar on the
left-hand side of the machine.
Place the work piece clamp (7) on the left or
right side of the machine.
Hold the handgrip and move the saw slightly
downwards and then pull the pin (5) out
slightly so that saw moves upwards.
Mount the support bracket (24) into the slot in
the rear of the base.
Tighten the screws to secure the support
bracket.
this case the machine must be secured to the
workbench with 4 bolts.
In this case the machine must be secured to
the subframe with 4 bolts and the subframe
anchored to the floor or to a floor plate with
dimensions of at least 1 square meter.
EN
9
Publicidad
