Operation Instructions - KOBE CH-100 Serie Instrucciones De Instalación Y Manual De Operación

OPERATION INSTRUCTIONS

This KOBE hood is equipped with four electronic controls with a 10-second standby startup &
30-second delay shutoff, powerful centrifugal squirrel cage with baffle filters, and bright 12-volt
20-watt halogen lights.
The four electronic controls are Light Control, Speed Control A, Speed Control B and the Power
Control (On/Off). Refer to Figure 18.
Light Control
TURN ON:
x
Press Power Control (On/Off) button once.
(Note: If any Control button is not pressed within 10 seconds, power will be
automatically turned off).
x
The KOBE hood will start on Low speed. Each press of the Speed Control
button will cycle through the various speeds.
x
Press Speed Control A button to cycle from Low, Medium, High, or
QuietMode¥ ¥ ¥ ¥ . Press Speed Control B button to cycle from Low, QuietMode¥ ¥ ¥ ¥ ,
High or Medium.
(Note: Speed Control A or B will operate both fans. These two speed buttons will
allow you to change the speed quicker.)
x
Press Light Control button to turn halogen light on.
x
Press the back Red button to turn on heating lamp.
(Note: Heating lamps are sold separately. Heating lamps required 120-volt,
175-watt.)
TURN OFF:
x
Press Power Control (On/Off) button once, panel lights will flash and power
will be completely shut off after 30 seconds.
OR
x
Press Power Control (On/Off) button twice, all power will be shut off
immediately.
x
If only the lights are on, pressing Power Control (On/Off) button once will turn
power off after 30 seconds.
Speed Control A
12
Figure 18
Power Control
Speed Control B