fILLING THE RESERVOIR BEfORE USE
•
Make sure that the appliance is unplugged.
•
Open the lid of the "Comfort Safety" System (5), check that the "Comfort
Safety" system full indicator/red pin (6) is NOT visible, fill the reservoir with
1 beaker (17) (Fig.1). Remember that the water level should not exceed the
maximum marker on the beaker.
•
Close the lid of the "Comfort Safety" system (5).
IMPORTANT! The blue lid for the "Comfort Safety" system
must be CLOSED for the unit to function.
USER INSTRUCTIONS
•
Attach the desired cleaning accessory and plug in the appliance.
•
The pilot light (4) will come on indicating that the appliance is plugged in.
•
When the steam cleaner/fabric steamer has the pressure required to operate,
the pilot light (4) will go off indicating that you can start to use it. This operation
will take approximately 2 minutes. During use, the pilot light will switch on and
off, indicating that the steamer is recovering the necessary pressure.
•
Press the steam control (2) to obtain steam.
•
We recommend pressing the control (2) repeatedly for short bursts rather
than just a few times for longer periods, so as to maintain pressure in the
boiler and increase the performance of the steam.
•
When you finish using the steam cleaner/fabric steamer, unplug it and wait
for it to cool down before removing the accessories.
•
We recommend that you empty the water tank if you are not going to use the
appliance again for an extended period of time.
06