Blade Settings - Husqvarna MS360 Manual De Instrucciones

• Fit the blade, blade flange and nut. Make sure that the
blade will rotate in the direction indicated by the arrow
on the blade.
• Close the blade guard. Tighten the locking knobs and
put the splash guard back.

Blade settings

Depth stop adjustment
Set the depth stop so that the blade gets maximum depth
without cutting into the cart.
CAUTION! This must be done while the blade is not
rotating.
The depth stop should be adjusted when switching to
other blade sizes. Check the stop depth regularly or
there is a risk that the cutting slot and the water system
will not function correctly.
• Loosen the locking knob for depth setting (1) and
lower the cutting arm.
• Loosen the lock nut (3).
• Loosen the depth stop adjustment knob (2).
2
• Push down the cutting arm until the blade hits the
bottom of the slot in the cart.
• Hold down the cutting arm in this position.
10 – English
ASSEMBLING AND ADJUSTMENTS
3
1
• Screw down the knob (2) for setting the stop depth
until the end of the knob abuts the underlying surface
in order to set up the stop depth of the blade. Turn
another turn to raise the head from the cart slightly.
• Tighten the locking nut (3).
• Tighten the locking knob for depth adjustment (1) with
the cutting arm still pushed down to its lowest position.
• Check the position of the blade by moving the
conveyor cart to its forward and rear end position. The
blade should never hit the cart.
Angle settings
90° ° ° °
• Loosen the lock knob for the mitre (1).
• Loosen the lock nut (2). Adjust the cutting arm so that
the lock knob for the mitre is at its lower end position
in the guide. Adjust the screw (3) so it bottoms on the
support arm.
3
• Tighten the locking nut.
2
3
1
1
2