Connecting Two Or More Cameras - Multi-Camera System - Sony ExwaveHad DXC-990 Instrucciones De Uso

Connecting Two or More Cameras — Multi-Camera System
Sync signal generator
Sync
(VBS or
BS) output
connector
VBS
OUT
VIDEO
IN
Video input
connector
Video monitor,
VCR, etc.
Notes
• Perform the following to synchronize the picture tone of the cameras when
switching between two or more cameras connected to a video switcher:
-Supply the same sync signal to the GEN LOCK IN connectors on the
cameras.
-Adjust the subcarrier and horizontal synchronization phases for all cameras.
For more details, see "Adjusting the Picture Tone in a Multi-Camera System"
on page 25.
• Turn on the power of the sync signal generator after all other equipment is
switched on
75-ohm coaxial cable
DXC-990/990P
TRIG IN
VIDEO
VIDEO OUT
OUT T
VIDEO
IN
Switcher, etc.
VBS OUT
75-ohm coaxial cable
DXC-990/990P
TRIG IN
VIDEO
VIDEO OUT
OUT T
DC IN/
VBS T
.
Set the MODE selector to
1
the [1] position.
2
CMA-D2/
D2MD/D2CE/
D2MDCE
camera
adaptor
MENU BLACK
FILE
BARS
SELECT WHITE
ENTER
RGB/SYNC
GEN LOCK IN
LENS MENU LOCK
ON
OFF
DC IN/
GEN LOCK
VBS
REMOTE
DC IN/
CCMC-12P02/05/
VBS T
10/25 cable
1
Set the MODE selector to
the [1] position.
2
CMA-D2/D2MD/
D2CE/D2MDCE
camera adaptor
MENU BLACK
FILE
BARS
SELECT WHITE
ENTER
RGB/SYNC
LENS MENU LOCK
ON
GEN LOCK IN
OFF
DC IN/ GEN LOCK
VBS
REMOTE
CCMC-12P02/05/10/25 cable
CAMERA
(12-pin)
Power
cord
CAMERA
(12-pin)
Power
cord
31
Connections
GB