Makita AN453 Manual De Instrucciones página 7

CAUTION:
Operating the tool without nails shortens the life of
•
the tool and should be avoided.
For squential trip trigger (accessory)
To drive a nail, you may place the contact element
against the workpiece and pull the trigger.
1
2
008397
CAUTION:
WITH THE TRIGGER HELD IN A HALF-PULLED
•
POSITION, an unexpected nailling could occur, if
contact element is allowed to re-contacct against
the workpiece or the other sueface under the
influence of recoil. In order to avoid this
unexpected nailling, perform as follows;
A. Do not place the contact element against the
workpiece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds
after nailling.
Jammed nailer
008399
CAUTION:
Always disconnect the air hose and remove the
•
nails from the magazine before cleaning a jam.
When the nailer becomes jammed, do as follows:
Open the magazine cap and remove the nail coil. Insert
a small rod or the like into the ejection port and tap it with
a hammer to drive out the nail jamming from the ejection
port. Reset the nail coil and close the magazine cap.
1. Trigger
2. Contact arm
1. Small rod
2. Ejection port
1
2
Nails
Nail
004310
Handle nail coils and their box carefully. If the nail coils
have been handled roughly, they may be out of shape or
their connector breaks, causing poor nail feed.
Avoid storing nails in a very humid or hot place or place
exposed to direct sunlight.
Humid
Nail
004311
MAINTENANCE
CAUTION:
Always disconnect the air hose from the tool before
•
attempting to perform inspection or maintenance.
Cleaning and removal of tat and dirt
Adhesion of tar and dirt to areas around the contact
element will prevent smooth movement of the contact
element (safety
discharge. Periodically clean the areas around the
contact element.
Use a solvent such as kerosene, #2 fuel oil or diesel fuel.
Immerse only the contact element and the areas around
the ejection port in solvent and remove tar and dirt with
brush. Always wear waterproof gloves to protect your
hands. Never immerse the housing, magazine, etc. in
solvent. Malfunction of the tool may result. Always
dispose of the solvent used in a safe and prudent
manner and in compliance with all local and national
code requirement.
7
Hot
mechanism), causing accidental