CH-3661 Uetendorf
- Pressing one of the function buttons 1-12 (For
programmes 7-12 first of all press the "SHIFT"
button) starts a cycle. The appliance stops
automatically at end of cycle. By re-pressing
the same button the cycle can also be prema
turely stopped (Alternatively, move the main
switch to the "OFF").
The 12 factory preset mixing programs are shown on page 61.
Watch out for unexpected operation after programmed pauses
(max. 5 secs) when all the 6 LEDs are not illuminated at once.
Saving the blending programmes:
- During manual operation
- Directly after blending press the "SAVE"
button to save the complete blending cycle.
Simultaneously press any chosen function
button (1-6) which can later be used to start
the blending cycle in Automatic Operation-
mode. Next the "SAVE" button flashes red
and the chosen button lights up orange as
confirmation.
- The shift function for saved programmes 7-12:
To use the save positions 7-12, firstly press the "SHIFT" button ("SAVE" button). When
active the "SHIFT" button lights up green. Afterwards re-press the "SAVE" button and
at the same time one of the function buttons (7-12), to which the blending cycle is to be
assigned.
Important!
Every saved cycle can be later overwritten except when the mixer is protected from
unintentional re-programming by a special code (See page 20) The max. cycle duration
is approx 4 mins; longer cycles cannot be saved. Interruptions of more than 5 secs
cannot be saved and define the beginning of a new cycle.
Pulse function
For short operating periods simply keep the "PULSE" button pressed and the blender will
operate until the button is released. This function can be selected in both manual and auto-
matic operating modes and overrides the blending cycle in operation.
Standard operation is "PULSE" button is programmed to operate at maximum speed. This
speed, however, can also be set to user's requirements. It is programmed in the same way
as the blending cycle is programmed.
- Setting desired speed in manual operation
seconds at this speed and then stop the blender by re-pressing the illuminated function
button.
- Finally press the "SAVE" button and the "PULSE" button at the same time and the
selected speed setting will be saved.
Instruction Manual
Rotor Memory Blender
blend drink 1:1.
1
: Allow the appliance to operate for a few
1
Appliance executes selected mix cycle:
corresponding LED illuminated
Mix cycle is saved:
"SAVE" button flashes and at the same time the
selected save position is illuminated
© Rotor Lips AG
21