FAAC S800H Guía Para El Usuario página 4

GENERAL SAFETY REGULATIONS
If correctly installed and used, the S800H automated system
ensures a high degree of safety.
Some simple rules on behaviour can prevent accidental
trouble:
- Do not pass between the leaves when they are moving. Wait
for the leaves to open fully before passing through them.
- Do not, on any account stay in between the leaves.
Do not stand near the automated system, and do not allow children,
persons or things to do so, especially when it is operating.
- Keep radio controls or other pulse generators away from
children, to prevent the automated system from being activated
involuntarily.
- Do not allow children to play with the automated system.
- Do not willingly obstruct leaf movement.
- Prevent any branches or shrubs from interfering with leaf
movement.
- Keep the indicator-lights efficient and easy to see.
- Do not attempt to activate the leaves by hand unless you have
released them.
- In the event of malfunctions, release the leaves to allow access
and wait for qualified technical personnel to do the necessary
work.
- When you have set manual operation mode, cut power to the
system before restoring normal operation.
- Do not in any way modify the components of the automated
system.
- Do not attempt any kind of repair or direct action whatever and
contact qualified personnel only.
- At least every 6 month: arrange for qualified personnel to
check the efficiency of the automated system and the safety
devices.
DESCRIPTION
These instructions apply to the following models:
S800H SB - S800H CBAC
The FAAC S800H automated system for swing leaf gates is a
hydraulic enbloc which, when installed invisibly in the ground,
does not alter the appearance of the leaf.
The model with a hydraulic shut-down facility does not require
installation of an electrical lock, as it guarantees mechanical
shut-down of the leaf when the motor is not operating. The model
without a hydraulic shut-down facility always requires one or more
electrical locks to ensure the leaf is mechanically shut down.
The S800H automated systems were designed and built to
automate swing leaf gates. Do not use for any other purpose.
Leaves of up to 4 mt and 800 Kg can be automated depending
on the selected model.
The functioning of the operators is controlled by an electronic
control unit, housed in an enclosure with adequate degree of
protection against atmosphere agents. The leaves are normally
in closed position.
AUTOMATED SYSTEM S800H
USER'S GUIDE
When the control unit receives an opening command via the
radio control or any other pulse generator, it activates the
hydraulic appliance which rotates the leaves until they reach
the opening position to allow access.
If automatic mode was set, the leaves close automatically after
selected pause time has elapsed.
If the semi-automatic mode was set, a second pulse must be
sent to close the leaf again.
A stop pulse (if supplied) always stops movement.
For details on the behaviour of the automated system in different
function logics, consult the installation Technician.
Automated systems include safety devices (photocells) that
prevent the leaves from moving when there is an obstacle in
the area they protect.
The S800H automated system is supplied standard with an
electronic device which, when connected to a suitable control
unit, detects the presence of a possible obstacle, and reverses
the movement of the leaf.
The warning-light indicates the current leaf movement.
MANUAL OPERATION
WARNING: BEFORE CARRYING OUT THE RELEASE AND
SHUT-DOWN OPERATIONS, MAKE SURE THAT YOU HAVE
CUT POWER TO THE OPERATOR.
HYDRAULIC RELEASE OF THE OPERATOR
If the gate has to be moved manually due to a power cut or fault
of the automated system, use the hydraulic release:
1) Unscrew the cover and remove it.
2) Turn the release screw (Fig.1 ref.a) inserting the triangular recess
of the supplied key (Fig.1 ref.b):
- To release, turn the release screw anti-clockwise up to the
mechanical stop point.
- To shut-down again, turn the release screw clockwise up to the
mechanical stop point.
b RELEASE KEY
a
RELEASE SCREW
Fig.1