Getting Started - Revell Control KA-58 Manual De Instrucciones

1. GETTING STARTED:

The throttle stick and throttle trim dial must be in the downward position before the controller is turned on. Move the controller's ON/OFF switch to "ON". Carefully
connect the helicopter's fl ight cable. The helicopter's control LED starts fl ashing red. Wait until the control LED emits a continuous GREEN light. Place the helicopter
two meters away on the ground with the tail pointing towards you. To start fl ying, move the throttle stick slowly forwards.
If the control LED in the helicopter does not emit a continuous GREEN light, check the position of the throttle trim dial and the throttle stick on the controller. A green
light means that the helicopter is ready for fl ight. If the control LED changes to RED during fl ight, the battery is too weak and needs to be recharged.
2. TRIMMING:
Correct trimming is crucial for ensuring that the helicopter fl ies smoothly. It is easy to do, but does require a little patience and a light touch. Please follow these instructions carefully: Slowly move the
throttle stick up to raise the helicopter to an altitude of about 0.5 metres to 1 metre.
If the helicopter spirals to the left or
right, or keeps turning slowly to the
left or right...
If the helicopter drifts quickly or slowly to the left, turn the lower
right trim dial gradually to the right. If the helicopter moves to the
right, turn the trim dial gradually to the left.
3. FLIGHT CONTROL:
The following information describes the individual functions of the control sticks on a mode 2 controller (throttle on left side). Please note that the position of the sticks is different to those on a mode 1
controller (throttle on right side). All of these functions should be used to ensure that the helicopter fl ies dynamically.
Mode 2 (throttle on left side) (
1
7 8 5
2
8
RC_Anleitung_Ka-58.indd 8 RC_Anleitung_Ka-58.indd 8
Flying the Helicopter
If the helicopter spins or rotates
If the helicopter spins or rotates slowly to the left on its own axis, turn
the lower left trim dial gradually to the right. If the helicopter turns to
the right, move the trim dial gradually to the left. Checking roll trim
may also help resolve these problems.
CONTROL REVERSE SWITCH SETTINGS
)
3
6
4
The control reverse switch enables you to change the settings controlling
the direction of the individual controls. However, we recommend that you
retain the default settings.
slowly on its own axis...
5 3 1 7
6 4 2 8
Distance 2 metres
If the helicopter keeps moving
forward or backward quickly or
slowly...
If the helicopter keeps moving forward quickly or slowly, turn
the upper right trim dial gradually down. If the helicopter moves
backward, turn the trim dial gradually up.
Mode 1 (throttle on right side) ( g
3
5 6 7
4
27.04.2009 16:14:31 Uhr 27.04.2009 16:14:31 Uhr
)
1
8
2