Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Instructions
This instruction manual must be read with particular attention to the following safety rules, by any person
installing or operating this tool.
1
Do not use outside the design intent.
2
Do not use equipment with this tool/machine other than that recommended by Avdel
3
Any modification undertaken by the customer to the tool/machine shall be the customer's entire responsibility.
4
Always fully disconnect the tool from the hydraulic pump unit before attempting to adjust, remove or fit the nose
assembly.
5
Do not operate a tool/machine that is directed towards any person(s).
6
Always adopt a firm footing or a stable position before operating the tool/machine.
7
It is recommended that ear and eye protection be worn by the operator and those in the vicinity.
8
Do not fit flexible hoses rated at less than 700bar (10,000 PSI) working pressure.
9
Avoid damaging hydraulic hoses. Avoid sharp bends and kinks when routing hydraulic hoses. Using a bent or
kinked hose will cause severe back-pressure. Sharp bends and kinks will internally damage the hose leading to
premature hose failure.
10 Do not drop heavy objects on hoses. A sharp impact may cause internal damage to hose wire strands and lead
to premature hose failure.
11 Do not lift the placing tool by the hoses. Always use the placing tool handle.
12 Do not pull or move the hydraulic pump unit using the hoses. Always use the pump unit handle or roll cage.
13 The operating pressure shall not exceed 550bar (8,000 PSI).
14 Care shall be taken to ensure that spent pintails are not allowed to create a hazard.
15 The flexible pintail deflector must always be attached to the tool and in good condition.
16 Take care to avoid entanglement of loose clothes, ties, long hair, cleaning rags etc. in the moving parts of the
tool.
17 The tool should be kept clean and dry for the best possible grip.
18 When carrying the tool from place to place keep hands away from the trigger to avoid inadvertent start up.
19 The machine must be maintained in a safe working condition at all times and examined at regular intervals for
damage and function by trained competent personnel. Any dismantling procedure shall be undertaken only by
personnel trained in Avdel
maintenance instructions. Contact Avdel
20 The machine shall at all times be operated in accordance with relevant Health & Safety legislation. In the UK
the "Health & Safety at Work etc Act 1974" applies. Any question regarding the correct operation of the
machine must be directed to Avdel
®
procedures. Do not dismantle the machine without prior reference to the
®
with your training requirements.
®
.
®
UK Limited.
3
Publicidad
Tabla de contenido
