Kohler K-11410 Guia De Instalacion página 9

Robe Hook
Wall Plate
Setscrew
Robe Hooks
8. Install the Robe Hook
Start a setscrew into each post. Do not thread fully into the post.
If included, slide an escutcheon onto the wall plate.
NOTE: The escutcheon sits loosely until the post is in place and the
setscrew is tightened.
Align the robe hook assembly over the wall plate.
Tighten the setscrew.
9. Install Cabinet Hardware
NOTE: The hole distance for the pull hardware is 3" (7.6 cm) on
center.
Mark a pilot hole at the desired location of the cabinet hardware
on the outside of the cabinet door.
Carefully drill through the cabinet at the marked location using a
3/16" drill bit.
Insert the end of the screw(s) from the inside of the cabinet out,
then partially thread the pull or knob to the end of the screw.
Hold the pull or knob in place while tightening the screw with a
screwdriver.
Kohler Co.
Cabinet Hardware
Pull Screws
Knob Screw
9 1044367-2-B