Hex Wrench Storage - Makita XPS01 Manual De Instrucciones

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.

Hex wrench storage

When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► 1. Hex wrench
Removing or installing circular saw
blade
CAUTION:
Be sure the circular saw blade is
installed with teeth pointing up at the front of the
tool.
CAUTION:
Use only the Makita wrench to
install or remove the circular saw blade.
To remove the circular saw blade:
1. Depress the lock-off button and lower the handle
a little. Turn the locking lever and lower the handle until
the lock pin fits in the hole.
1
► 1. Lock-off button 2. Locking lever 3. Lock pin
4. Hole for lock pin
2.
Press the shaft lock fully so that the blade cannot
revolve and use the hex wrench to loosen the hex bolt.
4
► 1. Shaft lock 2. Hex wrench 3. Tighten 4. Loosen
3. Remove the hex bolt, outer flange, and circular
saw blade.
12 ENGLISH
2
4
2
3
1
3
1