Festo DGCI Serie Manual De Instrucciones página 37

DGCI−...
The diagrams in Fig. 18 have a centre of gravity
distance r of:
35 mm with DGCI−18
50 mm with DGCI−25
Tip:
Use shock absorber supports KYC which can be shifted over the complete
stroke.
Check that the tubing is connected correctly.
S
Start a test run as described in the manuals for the controller.
S
Check that the settngs on the DGCI and all configuration data in the controllers
S
used (e.g. SPC200) are correct:
fixed stops
max. positioning range
movement sequence
no obstructions which limit movement.
When high demands are placed on the positioning behaviour of the SPC200.
Take into account a stroke reduction r for each end position. Only limited
S
positioning behaviour is available within the stroke reduction.
You will achieve the best possible position
ing behaviour with a stroke reduction of
10 % per end position. However, the stroke
reduction must not drop below the follow
ing values.
DGCI−...
Stroke reduction r
Fig. 21
When used with SPC11 (Soft Stop)
Make sure that the end stops are stable and cannot deform elastically.
S
Festo DGCI−... 0801a English
63
18
25
[mm] 20 25
Fig. 19
Fig. 20
32 40
25 35
63
35
37